How to Remove and Fit a Kitchen Tap

Install new taps to refresh a kitchen sink
You may choose to change your kitchen faucet for some reasons. It might not be working efficiently, or you might want to upgrade and refresh your kitchen. Either way, replacing a kitchen faucet is relatively easy with just a little planning and the correct tools for your task.

For this project, we will put in a monobloc mixer tap at a sink with one hole.

Tools & materials required
expanded, Before you Start
You will need to pick the right tap to your kitchen sink before you get started.

You may want to replace your present faucets with something similar, but you will also find alternatives to choose from if you’d like to freshen up the appearance of your kitchen. 2 Brothers Plumbing provide great plumbing service in South Yarra. With new finishes, colours and features available, there’s plenty of selections to suit every home.

Our Kitchen faucets purchasing guide will guide you through the options you will want to create, and enable one to understand which taps will suit your sink as well as the water pressure in your property.

Expanded, How to remove an old tap
Before you disconnect the pipework, make a note of which supply pipe is hot and which side is chilly. The easiest way to do so is by labelling a piece of masking tape and attaching to the pipe.

Step 1
Before beginning work, you’ll need to turn off your water supply.

In Case the pipes supplying your existing taps have isolating valves

Turn the supply of the cold and warm water away by turning the screw heads using a slotted screwdriver (or handle on the valve) so that they are in a right-angle to the stream of the pipe.

If the pipes Providing your Present taps don’t have isolating valves

You’ll need to turn off your water supply at the mains, by closing the stopcock. Once this was turned away, turn on the cold tap and allow the water to flow into the sold water storage tank and pipes are empty. This may drain the machine. You can turn off the tap after this point was reached.

Step 2
Clear out all you can from under the sink, including some shelves, but abandon the pipework in place. This will provide you more room to perform and use your resources more readily.

It is a good idea to propagate an old towel throughout the bottom of the sink cabinet to capture any spills and reduce clean-up time later. Once that is set up, put in a bucket or tray beneath the tap to catch any drips.

Step 3
With the water source isolated, you can now disconnect the water heater. Use one to hold and support the fitting and the other wrench to loosen the nut on the tap of the matching (not the lower one).

Step 4
Unscrew the loosened nut with your fingers. Underneath each nut is going to be a copper or brass olive. This is the part which produces the seal between the pipe and the fitting. When the nut is tightened, the olive is compressed onto the pipe, thus the title, a compression fitting.

Measure 5
You’ll need to remove the olive from each of the tap pipes to have the ability to remove the nuts. Alleviate the olive off with water pump pliers.

If the olive is apparently jammed in place, you might need to cut the olives off with a junior hacksaw or an olive splitter. We’d recommend an olive splitter since this lowers the risk of harm to the pipework, and is simpler to work with in a tight area.

Step 6
the nut that is screwed on the threaded bar that is connected to the foundation of the tap.

Leave a Comment

scriptsell.neteDataStyle - Best Wordpress Services